The World Material -

GCr15 Bearing Steel Introduction GCr15 steel is one of the most commonly used Chinese bearing steels, it's a high carbon chromium bearing steel with high hardenability, high & uniform hardness after heat treatment, high contact fatigue strength,…
Read More...

China 45 Steel Chinese GB standard 45 steel is a quality carbon structural steel, the cold plasticity is common. Annealing and normalizing are slightly better than quenching and tempering, and have high strength and good machinability. A certain…
Read More...

40Cr Alloy Steel 40Cr steel is a kind of Chinese GB standard alloy steel for engineering and machinery purpose, and one of the most widely used steel grades. For 40Cr material hardness, specifications and equivalent, please see the table below.…
Read More...

2Cr13 Stainless Steel Introduction Chinese 2Cr13 steel (20Cr13) is a martensitic stainless steel with magnetic properties, good corrosion resistance and high hardness in the quenched state. 2Cr13 stainless steel is used in a wide range of…
Read More...

T10 Tool Steel Properties T10 steel is a Chinese most common carbon tool steel with moderate toughness and low production cost. After heat treatment, material hardness can reach above 60 HRC. However, this steel has low hardenability and poor heat…
Read More...

T7 and T7A Tool Steel Properties T7 tool steel and T7A steel are Chinese tool steel grades, HBW hardness ≤187 (After annealing). After heat treatment (quenching or tempering), T7 tool steel can obtain higher strength and toughness, and corresponding…
Read More...

Q460 Steel Introduction Q460 steel is a Chinese steel grade of Low Alloy High Strength Structural Steel, Yield Strength is 460 MPa, data is tested with 16mm diameter steel bars or steel plates, tensile strength is 550-720 Mpa, test with steel bar…
Read More...

Q420 Steel Introduction Q420 steel is a Chinese steel grade of Low Alloy High Strength Structural Steel, Yield Strength is 420 MPa, parameters are tested with 16mm diameter steel bars or steel plates, and tensile strength is 520-680 Mpa, the…
Read More...

Q390 Steel Introduction and Specifications Q390 steel is a Chinese steel grade of Low Alloy High Strength Structural Steel, Yield Strength is 390 MPa, parameters are tested with 16mm diameter steel bars or steel plates, tensile strength is 470-630…
Read More...

Q215 Mild Steel Q215 steel is a Chinese carbon structural steel, divided into 2 quality grades: Q215A and Q215B, material density is 7.85 g/cm3. "Q" is the first letter of Chinese spelling of "Qu Fu Dian", translated as Yield Strength, "215" is a…
Read More...